Welcome to the stick center-calibration wizard!

This tool will guide you in re-centering the analog sticks of your controller. It consists in four steps: you will be asked to move both sticks in a direction and release them.

Please be aware that, once the calibration is running, it cannot be canceled. Do not close this page or disconnect your controller until is completed.

Calibration storage

By default the calibration is only saved in a volatile storage, so that if you (or this tool) mess something up, a reset of the controller is enough to make it work again.

If you wish to store the calibration permanently in the controller, tick the checkbox below:

Write changes permanently in the controller

Warning: Do not store the calibration permanently if the controller battery is low or disconnected. It will damage your controller.

Press Start to begin calibration.

Please move both sticks to the top-left corner and release them.

When the sticks are back in the center, press Continue.

Please move both sticks to the top-right corner and release them.

When the sticks are back in the center, press Continue.

Please move both sticks to the bottom-left corner and release them.

When the sticks are back in the center, press Continue.

Please move both sticks to the bottom-right corner and release them.

When the sticks are back in the center, press Continue.

Calibration completed successfully!

You can check the calibration with the gamepad tester.

Have a nice day :)